Bosch Refrigerator Error Codes
| Error Code | Causes |
|---|---|
| E01 | Refrigerator compartment temperature sensor is defective Learn More |
| E02 | Freezer compartment temperature sensor is defective Learn More |
| E03 | Temperature-controlled drawer temperature sensor is defective Learn More |
| E15 | Ambient temperature sensor is defective Learn More |
| E10 | Main control board module is defective Learn More |
| E11 | Display control module is defective Learn More |
| E20 | Communication error between the main control board module and the display control module Learn More |
| E21 | Communication error between display control module and the ice and water dispenser control module Learn More |
| E07 | Freezer evaporator sensor. No failure message during normal operation. After auto diagnostic test, E07 is displayed, if evaporator sensor fails. Learn More |
| E06 | Fridge evaporator sensor No failure message during normal operation. After auto diagnostic test, E06 is displayed, if evaporator sensor fails. Learn More |
| DOOR OPEN | When the door remains open for longer 30 s. Learn More |
Bosch Oven Error Codes
| Error Code | Causes |
|---|---|
| Er1 | Temperature sensor failure Learn More |
| Er2 | Faulty mains connection Learn More |
| Er4 | Temperature sensor failure Learn More |
| Er6 | Door lock faulty Learn More |
| Er7 | Door release mechanism faulty Learn More |
| F32 | Temperature sensor failure Learn More |
| F33 | Non-critical error. Ignore if not using the drawer frequently Learn More |
| F41 | Faulty Latch Motor Or Wiring Learn More |
| F43 | Faulty latch motor or its wiring Learn More |
| F45 | Defective or jammed upper oven door or latch switches Learn More |
| E305 | There is no connection between the baseplates Learn More |
| E115 | He temperature is too high Learn More |
Bosch Dishwasher Error Codes
| Error Code | Causes |
|---|---|
| E01 | Pump circuit failure or heating issue Learn More |
| E02 | Heater relay fault or heating issue Learn More |
| E03 | Auxiliary heater relay fault or water inlet valve failure Learn More |
| E04 | Heating fault or water issue Learn More |
| E05 | Water switch Triac fault or float issue Learn More |
| E06 | Door mechanism failure or aqua sensor fault Learn More |
| E07 | Drying fault Learn More |
| E08 | Loss of water Learn More |
| E09 | Heating fault Learn More |
| E10 & E12 | Slow heating Learn More |
| E11 | Thermistor or temperature sensor fault Learn More |
| E13 | Water temperature is too hot Learn More |
| E14 | Water inlet fault Learn More |
| E15 | Dishwasher is leaking Learn More |
| E16 | Water inlet fault Learn More |
| E17 & E18 | Not enough water Learn More |
| E19, E20, E21 | Heating issue Learn More |
| E22 | Blocked filter Learn More |
| E23, E24, E25 | Drain pump failure or clogged drain hose Learn More |
| E26 | Diverter motor fault (check the diverter valve) Learn More |
| E27 | Undervoltage error (check the power voltage) Learn More |
| E28 | Aqua sensor fault (see Error code E06 above) Learn More |
| E29 | Low mains voltage error (check the power voltage) Learn More |
Bosch Washer Error Codes
| Error Code | Causes |
|---|---|
| Er:01 | Door is open Learn More |
| Er:04 | Door lock relay won’t activate Learn More |
| Er:05 and Er:06 | Water temperature sensor is defective Learn More |
| Er:07 | Unexpected heating (water heats up without the control module activating the heater) Learn More |
| Er:08 | Heating time exceeded (heater doesn’t turn off) Learn More |
| Er:09 | No communication between control module and motor control module Learn More |
| Er:11 and Er:12 | Water fill time exceeded Learn More |
| Er:13 | Drain time exceeded Learn More |
| Er:14 | Overfill level reached Learn More |
| Er:17 | Aquastop error Learn More |
| Er:20 | Spin cycle terminated Learn More |
| Er:21 | Excessive foam detected Learn More |
| Er:22 | Electrical power supply problem Learn More |
| Er:25 | Door lock is blocked Learn More |
Bosch Dryer Error Codes
| Error Code | Causes |
|---|---|
| E01 | Overheating due to clogged exhaust air path Learn More |
| E:03 or E:13 | Maximum drying time exceeded Learn More |
| E:17 | Lint screen temperature sensor error Learn More |
| E:18 | Heater temperature sensor error Learn More |
| E:20 through E:26 | Defective control module Learn More |
| E02 | The fluff filter of your dryer has become blocked with fabric softener residue Learn More |
| E06 | Оccurs because of a Fault with the heating circuit Learn More |
| E28 | Occurs because of a Fault with the electronics Learn More |
| E90 | Occurs because of a Fault with the electronics Learn More |